Roll Cage & Pallet Lifter

Standard Features

• Lowerable ladder for safe access for personnel
• Rubber buffered wings to limit entry into rear of vehicle
• Retention rope to minimize cage movement
• Maximum fork section 100 x 45 mm at 1000 mm centres
• Painted bright orange for safety

Operation

• The product must be positioned on level ground.
• Position the forks to the correct distance apart to locate into fork pockets.
• Drive forks fully into fork pockets.
• Unlatch the safety chains and re-couple to keep bracket.
• Load the load lifter with 2 or 3 cages (dependent upon type of cage).
• Re-attach the safety chains.
• Lift the load lifter so that the two retaining brackets (Yellow in colour) fully engage with the forklift carriage.
• Apply required back tilt of the forklift mast.
• Proceed to the open lorry approaching square on and not angular.
• Lift the Load lifter above the lorry bed height and proceed forward into the lorry so that the side handrails are within the sides of the lorry.
• Realign forklift mast to the vertical position and lower onto the lorry bed ensuring that the retaining brackets are still engaged to the forklift carriage.
• Unlatch the safety chains and re-couple to keep bracket and remove the cages
• Once empty lift the Load lifter and reverse away for the next operation.

HERMEQ stock a wide range of Handling & Lifting, Vehicle & Container Access, Trench Covers & Road Plates conforming to all required safety specifications and regulations.